TFH Series Fluff Feed Hoppers

The patented TFH hopper pedestal assembly maintains separation of fluff and pellets until mixed in the patented "Verti-Blend" mixer directly above the extruder screw.

TFH Series re-feed systems are designed to run at a set percentage of current extruder revolutions per minute (rpm). Signal isolation circuitry receives extruder tachometer signals to determine system rpm. Each auger (horizontal fluff feed and vertical mixing) can be adjusted independently, using the controls on the front panel.

• Up to 30% maximum re-feed rate
• Independently adjustable vertical mix auger and horizontal fluff metering auger
• Individual speed adjustments, utilizing variable frequency inverter drives
• Horizontal and vertical drive AC inverter-duty motors
• Optical level sensor with delay timer, with field connection to grinder feed rolls or alarm device

Fluff feedback rate is based on a non-extruder limited line, recycling 1.25 mil LDPE medium slip film. Extruder screw speed increase may be required to obtain maximum quoted feed rate. If extruder is running 100% platicising capacity on virgin material, loss in output may occur during fluff feeding.

AEC/HydReclaim, 3145 Copper Avenue. Tel: 810-629-6441; Fax: 810-629-5088.