PRO-CON PROfile measurement and CONtrol

The same measurement technology as the PRO-FIL is used to measure the film tolerance. Additionally the patented PLAST-CONTROL segmented air ring is placed on top of the die which channels the standard cooling air into small segments. The volume of air flow is adjusted as needed within each segment which will correct for gauge variations during the blow-up process.

Options

• Segmented air ring is available in 3 die size ranges
• Type HL4/32 from 5.9" (150mm) - 9.8" (250mm)
• Type HL5/48 from 7.9" (200mm) - 19.7" (500mm)
• Type HL6/56 from 15.8" (400mm) - 23.6" (600mm)
• Single or dual lip designs
• Changable lip inserts allows for changing die sizes
• Infrared communications for full rotating dies
• Upgrade to include Width measurement and control
• Upgrade to include extrusion control as with ACS system
• Remote modem service
• Ethernet communication

Benefits:

• Simple operation
• Retrofit of all existing lines or for new installations, mono and co-extrusion
• Self calibration, no samples required
• Mapping to die bolts for all applications including rotating/oscillating dies
• Automatic setup to die bolt locations
• With scanner automatic for changes in bubble diameter
• Cross sectional gauge variation reducted up to 50% of original profile
• Closed loop circuitry provides accurate control
• For HDPE/LDPE/LLDPE film
• No additional energy required
• Special air ring design for higher output rates available

Plast-Control, Inc., 29 Green Street. Tel: 978-462-0306; Fax: 978-462-1425.