Product/Service

IHCO Design

Source: Industrial Heater Corp.
In order to satisfy the demand for air-cooled assemblies and replacement elements, IHCO designed and manufactures complete units for replacement with the following factors in mind:
  • The major
In order to satisfy the demand for air-cooled assemblies and replacement elements, IHCO designed and manufactures complete units for replacement with the following factors in mind:
  • The majority of extruders manufactured in Europe and the Pacific incorporate air-cooling
  • Air-cooling has been proven the most econo- mical method of cooling
  • Air-cooling is the most trouble-free method of cooling
  • Air-cooled heating elements are less costly than water-cooled heating elements
  • Air-cooled elements have a longer service life
  • Air-cooling eliminates water leaks and contamination
  • Air-cooling eliminates the need for water pipes
  • No heat exchanger is required with air-cooling
  • Air-cooled elements are easy to install
FEATURES
  • Self-contained
  • Compatible with most extruders
  • Low cost to purchase
  • Low cost to operate
  • Replaceable heating elements
STANDARD CONSTRUCTION
  • 1. Ceramic heating elements
  • 2. Hinged aluminized steel shroud
  • 3. 120 volt blower
  • 4. Thermocouple hole
  • 5. Screw terminals outside shroud with cover box
Recommended Wattage
  • Ceramic heating elements (maximum tempera- ture 1000oF)– 30 WSI
  • Mica heating elements (maximum temperature 800oF)– 25 WSI
  • Finned cast-in heating elements (maximum tem perature 850oF)– 40 WSI

Industrial Heater Corp., 30 Knotter Drive. Tel: 203-250-0500; Fax: 203-250-0599.