Product/Service

Auto Series Lab Presses now Available in "CE" Models

Source: Carver, Inc.
Auto Series Lab Presses now Available in "CE" Models
CARVER® AUTO SERIES LABORATORY PRESSES NOW AVAILABLE IN "CE" MODELS

Wabash, IN-The CARVER Auto Series hydraulic laboratory presses are now available in "CE" models that are approved for us

CARVER® AUTO SERIES LABORATORY PRESSES NOW AVAILABLE IN "CE" MODELS

Wabash, IN-The CARVER Auto Series hydraulic laboratory presses are now available in "CE" models that are approved for use in Europe. In addition to the standard safety shield and "anti-tie-down" start buttons, these presses include an electrical disconnect, European safety devices and "CE" nomenclature on the control panel. An operator's manual, written in the language spoken at its destination, is also included. Most other CARVER presses, including the manual models, are also available in "CE" format.

Typical of the Auto Series "CE" models is the Carver Auto Four. Completely self-contained, the presses are available with 15 or 30 ton clamp force and are equipped with either 12" X 12" heated or unheated platens. The heated platens feature digitally controlled cartridge heaters.

Engineered with a unitized base, the presses are easy to install. Designed with the operator in mind, they also feature and integral safety shield that surrounds the work area for safe operation. A clear, impact-resistant access door allows unobstructed observation. Dual operator buttons with "anti-tie-down" require two hand operation for safety. Threaded rods that allow daylight opening adjustment and cast iron bolsters are also standard.

Options include microprocessor controls for accurate, programmable operations; higher operating temperatures; individual temperatures controllers and base stand. For more information, contact Carver, Inc., 1569 Morris Street, P.O. Box 544, Wabash, IN 46992-0544, telephone 219-563-7577. Fax 219-563-7625.

Carver, Inc., 1569 Morris St., P.O. Box 544. Tel: 219-563-7577; Fax: 219-563-7625.