Product/Service

Transducer Tester

Source: RJG, Inc.
The RJG, Inc., Mold Pressure Transducer Tester, P/N T-TTST, is designed to test the operation of standard RJG mold pressure transducers.

Battery Operated
The Battery Powered unit is de

The RJG, Inc., Mold Pressure Transducer Tester, P/N T-TTST, is designed to test the operation of standard RJG mold pressure transducers.

Battery Operated
The Battery Powered unit is designed for portable, hand-held operation.

Easy to Use
A simple LED graph indicates if the Zero Balance and Shunt Calibration are within acceptable range, and if the transducer is responding to applied loads.

Powerful Troubleshooting
By indicating pre-load and side-load conditions, this valuable device can confirm correct installation of the sensor before the tool leaves the toolmaker. The Transducer Tester will also confirm correct operation of the sensor before, during, and after each run.

RJG, Inc., 3111 Park Drive. Tel: 231-947-3111; Fax: 231-947-6403.