Pyrowatt® Cartridge Immersion Heaters
Source: Industrial Heater Corp.
IHCO PYROWATT cartridge IMMERSION HEATERS have standard flex leads. Screw contacts can be specified as a design variation in sizes shown on the chart. Octagonal junction boxes are available for 5/8",
IHCO PYROWATT cartridge IMMERSION HEATERS have standard flex leads. Screw contacts can be specified as a design variation in sizes shown on the chart. Octagonal junction boxes are available for 5/8", 3/4" and 1" heaters. Consult IHCO about moisture control boxes. The heaters incorporate NPT bushings when installed through bulkheads or walls of tanks and are available with either brass or 304 stainless steel bushings. FEATURES
high watt density
- High temperature potential in a small package
- Flex leads with Teflon insulation standard
- Screw terminals optional
- RTV sealant at lead end, welded-end disk opposite end
- NPT bushings, single threaded
Standard construction is 3/4" diameter with 3/4" NPT bushing end-sealed with RTV, 12" fiberglass-insulated leads with silicon rubber sleeving. DESIGN VARIATIONS
Fitting can be moved to 2 1/2" from lead end if required. All diameters have double-thread bushings (running thread, NPT thread) where two or more nuts are used. Conduit boxes with knockouts can be attached using double-threaded bushings (3/4" diameter). DESIGN SPECIFICATIONS/TOLERANCES
Wattage: NEMA standard plus 5%, minus 10% Resistance: NEMA standards
Industrial Heater Corp., 30 Knotter Drive. Tel: 203-250-0500; Fax: 203-250-0599.
This website uses cookies to ensure you get the best experience on our website. Learn more